So I have a double float for the water filling and waterfalls pump cut off so that my plumbing doesn’t break and dump my pond into the backyard and kill all my fish. That would not be good. So I designed a bracket to hold the float in the water off of the rock face.
So a co-worker of mine needed some spacers for a trailer that was customized. It has box on it and he got a plate made to go in the bottom of it but needed to keep a gap between the plate and bottom of the box In case water got in. He will be putting rubber feet on them to keep them from sliding.
So this is a design that I like a lot. This is based on parameters done inside of CAD. I could not find a battery solution that fit my needs. I bought one or two of the organizers from Amazon and didn’t like them so I made my own.
So this is something I worked on for a month. Did a lot of testing and fitting.The idea was to create a interchangeable picture box so that the pictures could be updated over time. The pictures are a lithophane that are 3D printed and they require to be back lite. Each one has 6 LEDs and a battery pack but can also be ran on a power supply.
This was a small battery operated fan that was around the house and somehow got broken...
This was a fun and a learning experience using Fusion 360.